EC Skill / Practical learning
Hardware Lab
Learn embedded systems hands-on — no hardware needed
6 guided labs · firmware study · knowledge checks
Lab 01
Beginner
Blink an LED on STM32
Learn GPIO output by blinking the onboard LED on an STM32 Blue Pill.
STM32F103C8T6 (Blue Pill)
STM32
Start LabLab 02
Beginner
UART Communication on STM32
Send debug messages from an STM32 Blue Pill to your PC with USART1.
STM32F103C8T6 (Blue Pill)
STM32
Start LabLab 03
Beginner
Button Input — Toggle LED on STM32
Read a push button on PA0 and toggle the Blue Pill LED with STM32 HAL.
STM32F103C8T6 (Blue Pill)
STM32
Start LabLab 04
Intermediate
Read an ESP32 analog input
Configure ADC1 oneshot mode and understand why a raw ADC count is not automatically a voltage.
ESP32 · ADC oneshot
ESP32
Start LabLab 05
Beginner
Your first Arduino LED blink
Use pinMode and digitalWrite to change the Uno’s built-in LED at regular intervals.
Arduino Uno · GPIO
Arduino
Start LabLab 06
Intermediate
Read a button safely
Use the internal pull-up resistor and interpret the button’s active-low input state.
Arduino Uno · Digital input
Arduino
Start LabExplore the chip before you code
Open the existing 3D package and pinout explorer.